i hate cutting mats and i htink i just screwed up $40 worth of it. when your prints are small, how does one go around doing this? i can't continue going all the way down to 32nds of an inch.
plus, i f-ed up my first one with the whole bevel thing. it don't work so well when the bevel faces the back of the mat.
stress level: rising quickly.
oh gah!
ReplyDeletei hate cutting mats and measuring and stuff... i get easily confused and i tend to have to round to the half inch b/c i just can't figure out smaller stuff, or count on it being accurate (hence i fucked up 5 mats b/c i tried to be too precise). it would be hard to mat stuff so small... good luck. just be patient is all i can recommend!